Thanks @monomonnik ! I had a feeling I needed to target the previous point and was unsure how to do it.

There are a few issues I ran into when porting your example over that I think are specific to how the point data is stored in the .UFO

I ran into this error

```
Traceback (most recent call last):
File "<untitled>", line 14, in <module>
TypeError: 'RPoint' object is not subscriptable
```

When I print `segment[0]`

I get the following output:

```
<RPoint offcurve (311, 717) at 140588776786576>
```

I adjusted your example to the following which targeted the x and y for each segment rather than the third array

```
x1,y1 = segment[0].x, segment[0].y
x2,y2 = segment[1].x, segment[1].y
x3,y3 = segment[2].x, segment[2].y
```

Which allowed the code to run but it looks like there's something about one of the last off curve points in the loop not drawing to the proper on curve point and closing the path improperly on some of the drawings.

I ran into the same issue with different glyphs as well just to make sure there wasn't something wrong with my drawing.

The above results were from running the script as such:

```
g = CurrentGlyph()
newPage(1000,1000)
P = BezierPath()
diameter = 10
translate(240,100)
# DRAW CONTOURS
for contour in g.contours:
# DEFINE STARTING POINT
x3,y3 = (contour[0][0].x,contour[0][0].y)
P.moveTo((x3,y3))
for segment in contour:
x0,y0 = x3,y3
# IF IT'S A CURVE DRAW A CURVE
if len(segment) == 3:
x1,y1 = segment[0].x, segment[0].y
x2,y2 = segment[1].x, segment[1].y
x3,y3 = segment[2].x, segment[2].y
P.curveTo((x1,y1),(x2,y2),(x3,y3))
# SHOW THE OFF CURVE POINTS
oval(x1-diameter/2,y1-diameter/2,diameter,diameter)
oval(x2-diameter/2,y2-diameter/2,diameter,diameter)
# SHOW THE ON CURVE POINTS
rect(x3-diameter/2,y3-diameter/2,diameter,diameter)
#DRAW A LINE
stroke(0)
line((x2,y2),(x3,y3))
line((x0,y0),(x1,y1))
# IF IT'S A LINE DRAW A LINE
if len(segment) == 1:
x,y = segment[0].x, segment[0].y
P.lineTo((x,y))
#SHOW POINTS
rect(x-diameter/2,y-diameter/2,diameter,diameter)
P.closePath()
fill(None)
stroke(0)
drawPath(P)
```

Thanks again for your help and insight