Dear @gferreira,
I tried to use your suggestion it in my exercise and it worked fine. Thank you so much for your help! Amazing.
Thank you and kind regards,
Petra
Petra Rüth
@Manufraktur
Research on blackletters, Type Design, Calligraphy
Posts made by Manufraktur

RE: draw arc

RE: draw arc
Dear @gferreira,
thanks for your quick reply. It seems like this could solve my problem. I will give it a try tomorrow and let you know.But thank you already so much for your help!
Petra 
draw arc
Hi there,
I am not sure if this is the correct category to post this.
I am trying to draw an arc and I cannot find any example or explanation concerning this. In the documentation it says:
arc(center, radius, startAngle, endAngle, clockwise)
but it didn't work.
Assuming the center has two coordinates, I tried:
arc((10, 10), 10, 20, 25, True)
and
arc(10, 10, 10, 20, 25, True)
, both didn't give a result.There were a few discussions and examples about arcTo(), but that didn't help me as I am trying something like this:
Did anybody try something similar before?
Thank you in advance for your help,
Petra